Filter - Festool CT 26 E HEPA Original Instructions Manual

9.3 Extracting fluids
WARNING
Risk of injury
► Do not evacuate combustible liquids!
The main filter shall only be used for ex­
tracting dry materials.
Before extracting fluids, remove the filter bag
(see chapter 10.1). We recommend using a
special wet filter.
The dust extractor stops automatically when
the maximum level is reached.
CAUTION
Escaping foam and fluids
► Switch off the machine immediately and
empty the dust container.
CAUTION
Hazardous dust
Damage to the respiratory passage
► After extracting wet materials, remove the
wet filter and replace it with the main filter
for dry materials.

10 Filter

WARNING
Risk of injury
► During the following procedure, take care
not to raise dust more than is unavoidable.
Moisten the main filter with a water spray
before removing it.
10.1 Changing the filter bag
Inserting the filter bag
► Open the locking clips [2-2] and remove the
top section of the machine [2-1].
► Insert a new filter bag (SC-FIS-CT 26/36/48)
(Fig. [5]) in the inlet port of the dust con­
tainer and interlock it. Important: be aware
that the locking engages.
Make sure that the filter bag is not pinched
between the top and bottom sections.
► Replace the top section [2-1] and close the
locking clips [2-2].
5
SC-FIS-CT 26/36/48
2
Removing the filter bag
► Open the locking clips [2-2] and remove the
top section of the machine [2-1].
► Remove the filter bag (Fig. [6]).
► Dispose of the used bag in accordance with
statutory regulations.
► Clean the dust container [2-3].
► Insert a new filter bag if necessary.
2
6
► Replace the top section [2-1] and close the
locking clips [2-2].
10.2 Changing the disposal bag
Inserting the disposal bag [7]
► Open the locking clips [2-2] and remove the
top section of the machine [2-1].
English
1
3
1
3
13