Filter - Festool CT 26 E HEPA Instruction Manual

Extracting dry materials
WARNING
Not suitable to vacuum hazardous or toxic sub-
stances or dusts e.g. asbestos.
The filters will not be able to capture all particles
and may exhaust them back into the environment.
Remember: A damp main filter will clog more
quickly when dry materials are extracted. There-
fore, dry the main filter before extracting dust or re-
place the damp filter with a dry one.
Extracting fluids
WARNING
Risk of injury
Do not evacuate combustible liquids!
WARNING
Risk of injury
During the following procedure, take care not to
raise dust more than is unavoidable. Moisten the
main filter with a water spray before removing it.
Changing the filter bag
Inserting the filter bag
Open the locking clips [2-2] and remove the top
section of the machine [2-1].
Insert a new filter bag (SC-FIS-CT 26/36/48)
(Fig. [5]) in the inlet port of the dust container
and interlock it. Important: be aware that the
locking engages.
Make sure that the filter bag is not pinched be-
tween the top and bottom sections.
Replace the top section [2-1] and close the
locking clips [2-2].
The main filter shall only be used for extracting
dry materials.
Before extracting fluids, remove the filter bag (see
chapter "Changing the filter bag").
mend using a special wet filter.
The dust extractor stops automatically when the
maximum level is reached.
CAUTION
Escaping foam and fluids
Switch off the machine immediately and empty
the dust container.

Filter

2
5
Removing the filter bag
Open the locking clips [2-2] and remove the top
section of the machine [2-1].
Remove the filter bag (Fig. [6]).
Dispose of the used bag in accordance with stat-
utory regulations.
Clean the dust container [2-3].
Insert a new filter bag if necessary (see Insert-
We recom-
1
3
SC-FIS-CT 26/36/48
13