Suction Force Regulator; Temperature Control; Connecting An Electric Tool; Operation - Festool CT MINI HEPA Instruction Manual

3.1
3.2
3.3
3.4

Suction force regulator

The suction force regulator (1.2) lets you set the
suction force that works best for the material to
be vacuumed up.

Temperature control

A heat-triggered limit switch turns off the dust
extractor if it reaches a critical temperature,
to protect against overheating. If this happens,
switch the dust extractor off and let it cool for
around 5 minutes. If the dust extractor still can-
not be switched back on, consult a Festool service
center.

Connecting an electric tool

Observe the maximum connected load on the tool
plug socket (see "Technical Data"). The tool's rated
power consumption must not exceed this!
Plug the tool power cord to the tool plug socket
(1.3).
when you plug or unplug it!

Operation

2.1
take care not to raise unnecessary dust.
2.2
Changing the fi lter bag
- Open locking clips (1.4), remove top section
(1.5).
- Change fi lter bag (2.1) – see instructions printed
on fi lter bag.
- Replace top section, close locking clips.
without a fi lter, as doing so may damage the mo-
tor.
- Open locking clips (1.4), remove top section
(1.5).
- Fold over handle (3.1) and remove holder (3.2).
- Remove used fi lter (3.3) and replace with a new
one.
- Replace holder and fold over handle until it
latches into place.
- Replace top section, close locking clips.
7
Make sure the tool is switched off
During the following procedures,
Changing the fi lter
Do not operate this dust extractor