Table of Contents
Advertisement
Operating Instructions
A
B
Setup
1. Place the ram (A) between the two halves of the
frame unit (F).
2. Insert the cylinder head pins (C) through the frame
unit (F) and ram (A). Secure the cylinder head pins in
place with the spring clips (D).
3. Select the bending shoe (K) that corresponds to the
size of conduit to be bent.
4. Attach the shoe to the shoe support (K) with the
shoe pin (J). Attach the shoe support to the ram (A)
with the ram pin (E).
5. Place the pipe supports (G) into the frame, locating
them in the hole positions that correspond to the
size of conduit or pipe to be bent. Insert the pipe
support pins (H) through the upper frame, through
the pipe support, and through the lower frame. Turn
the thumb screws clockwise to secure the pipe
supports.
Greenlee Tools, Inc.
C
F
D
H
6. Position the pipe support so that the side of the pipe
support facing the conduit corresponds to the size
of conduit to be bent.
7. Connect the high-pressure hydraulic hose (B) to the
ram (A) and to the pump (not shown).
Note: Clean the quick-change couplers before making
Follow the instructions and safety information
supplied with your hydraulic pump.
4
880 Hydraulic Bender
H
I
G
the connections. Hand-tighten the coupler
completely. Do not use tools.
IMPORTANT
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
G
K
E
J
Advertisement
Table of Contents
