Godox V860 III Instruction Manual page 25

RX
GR CH SYNC
- 47 -
2
Receiver Unit Setting
● Set the V860IIIO that to be
controlled as the wireless
receiver unit.
● The receiver unit can be
set as A/B/C/D/E.
3
Check the communication
channel.
● If the transmitter unit and
receiver unit(s) are set to a
different channel, set them
to the same channel.
(Page 45)
4
Position the camera and
flashes.
● Position the camera and
flashes as the picture
shows. (Page 44)
5
Check that the flash is
ready.
● Check that the transmitter
flash ready indicator is
lightened.
6
Check the flash operation.
● Press the transmitter unit's
Test Button < >.
● Then, the receiver unit will
fire. If not, adjust the
receiver unit's angle toward
the transmitter unit and
distance from the
transmitter unit.
Using Automatic Wireless Flash with Multiple Receiver Units
When stronger flash output or
more convenient lighting operation
is needed, increase the number of
receiver units and set it as a
single receiver unit.
To add receiver units, use the
same steps as setting "automatic
wireless flash with a single
receiver unit". Any flash group can
be set (A/B/C/D/E).
When the number of receiver units
is increased and the transmitter
unit flash firing is ON, automatic
control is implemented to make all
groups of flashes fire the same
flash output and ensure the total
flash output up is to standard
exposure.
●
If the receiver unit's auto power off function is workable, press the
transmitter unit's test button to power it on. Please note that test firing is
unavailable during the camera's regular metering time.
●
The effective time of receiver auto power off is changeable. (C.Fn-RX
STBY Page 55)
Using Fully Automatic Wireless Flash
The FEC and other settings that set on the transmitter unit will also
be appeared on the receiver unit automatically. The receiver unit
does not need any operation. Use the following settings to make
wireless flashes according to the same methods with normal flash
shooting.
● Flash Exposure Compensation (Page 39)
About Transmitter Unit
Use two or more transmitter units. By preparing several cameras
that with transmitter units flash attached, cameras can be changed
in shooting while keeping the same lighting source (receiver unit).
- 48 -