Wireless Settings; Group Mode Selection; Setting The Communication Channel; Wireless Id Settings - Godox V860 III Instruction Manual

1. Wireless Settings

You can switch between normal flash and wireless flash. For normal
flash shooting, be sure to set the wireless setting to OFF.
Transmitter Unit Setting
Receiver Unit Setting
RX
CH SYNC

2. Group Mode Selection

3. Setting the Communication Channel

If there are other wireless flash systems nearby, you can change the
channel IDs to prevent signal interference. The channel IDs of the
transmitter unit and the receiver unit(s) must be set to the same.
C.Fn Ver 0.5
SCAN STBY
CH 07
ID
BEEP
CLEAR
- 45 -
Press < > button so that < >
is displayed on the LCD panel.
Press < > button so that < >
or < > are displayed on
RX
the LCD panel.
1
Short press the Function
Button 1 and <M> group
can be changed in
OFF/TTL/M. Choose one of
them as transmitter unit's
flash mode.
2
Short press the <MODE>
button to gain Multi mode.
1
Press <MENU> Button to
enter C.Fn CH setting.
2
In C.Fn CH, turn the Select
Dial to choose channel ID
from 1 to 32.
3
Press the Set Button to
confirm.

4. Wireless ID Settings

Change the wireless channels and wireless ID to avoid interference
for it can only be triggered after the wireless IDs and channels of the
transmitter unit and the receiver unit are set to the same.Press the
<MENU> button to enter C.Fn ID. Press the Set Button to choose OFF
channel expansion shutdown, and choose any figure from 01 to 99.
C.Fn Ver 0.5
SCAN STBY
CH 99
ID
BEEP
CLEAR

5. Scan the Spare Channel

To avoid the interference of using the same channel by others, this
function can be used: enter the C.Fn settings and find the SCAN
option. When setting it to START, it will scan from 1% to 100%. And
the 8 spare channels will be displayed after the scan is completed.
C.Fn Ver 0.5
SCAN
CH
ID
22 08 32 23
30 21 07 06
BEEP
CLEAR
6. TTL Fully Automatic Wireless Flash Shooting
Using Automatic Wireless Flash with a Single Receiver Unit
1
Transmitter Unit Setting
● Attach a
V860IIIO camera
flash on the camera and
set it as the transmitter
unit.
● M/A/B/C can be set as TTL
mode independently.
- 46 -