Cleaning And Maintenance - Beurer maremed MK 500 Instructions For Use Manual

1. Once lights up on the touch display, press the ON/OFF button
maremed .
®
2. Pull the mains plug out of the socket.
3. Remove the mains plug from the maremed
4. Unscrew the cover of the UVC lamp. Remove the cover.
5. Remove the UVC lamp from the housing as shown.
6. Carefully insert a new UVC lamp until you feel and hear it click firmly into place.
7. Replace the cover of the UVC lamp. Screw down the cover of the UVC lamp again.
8. Insert the mains plug into a suitable socket.
9. After inserting the new UVC lamp, press and hold the FAN button
button simultaneously. The lamp symbol
10. The operating hours counter now resets to 0.

8. Cleaning and maintenance

WARNING
Before cleaning, always ensure that the maremed
Never clean the maremed
IMPORTANT
Regular cleaning is a prerequisite for hygienic and fault-free operation. The maremed
be dismantled for cleaning with ease and without tools.
Empty and clean the tank after each use with a diluted water and vinegar essence
solution.
Clean the water filter after each use with clean tap water. If you do not intend to use
the maremed ® for an extended period of time, leave the water filter and open tank to
air-dry for a week.
® if it is connected to the mains.
681.19_MK500_2019-05-28_01_Display_BEU
.
®
will go out on the touch display.
® is disconnected from the mains.
681.19_MK500_2019-05-28_01_Display_BEU
35
to switch off the
and the ON/OFF
® can