Setting Up The Maremed - Beurer maremed MK 500 Instructions For Use Manual

To fill the tank, proceed as follows:
1. Ensure that the maremed
2. Remove the cover from the maremed
3. Fill the tank fully up to the MAX marking (approx. 6 litres) with fresh, cold tap water.
4. Using the measuring jug, add 90 ml of the maremed
ery to the tap water.
(For every 1 litre of tap water use 15 ml of maremed
5. First place the tank in the desired location and then put the cover back on top of the
maremed housing. To avoid water splashing into the upper cover, do not carry the cover
together with the tank filled with water.
Note
When carrying the device, only use the recessed handles at the front and back provided
for this purpose. The top recesses are merely for taking off the cover.
IMPORTANT
Empty and clean the tank after each use with a diluted water and vinegar essence
solution.
Clean the water filter after each use with clean tap water! If you do not intend to use
®
the maremed for an extended period of time, leave the water filter and open tank to
air-dry for a week.
If it is not cleaned adequately, bacteria, algae and fungi may form in the water and
on the water filter.

7.2 Setting up the maremed

1. Place the maremed
and noise.
2. Set up the maremed
3. Make sure that the air inlet and air outlet are never blocked.
4. Make sure that the touch display is facing the front.
® is disconnected from the mains.
®
®
® on a firm, level and water-resistant surface to prevent vibrations
® in such a way that there is 30 cm clearance on all sides.
in an upward direction.
® special sea salt included in deliv-
® special sea salt).
31