Inserting The Batteries; Setting Date & Time; Changing Batteries - inventum BM 20 Instruction Manual

– Protect the computer from shocks and be careful not to drop it,
– Protect it against moisture, dirt, wide fluctuations in temperature and the direct rays of the sun,
– Only ever use the cuffs provided with the monitor or original replacement cuffs. Otherwise incorrect
results will be recorded.
– To prevent any hazard as a result of the cuff tube, keep the tube out of children's reach and never
put it round your neck.
– Do not use it in areas where there are strong electromagnetic fields, i.e. keep it away from
transmitters and mobile phones.
• Do not press buttons without the cuff fitted.
• Use the appliance only on people with an upper arm circumference that is within the range recommended
for this appliance. As a rule, these are adults.
• If the computer is not used for a lengthy period of time, it is advisable to remove the batteries.
• Keep the batteries out of reach of children. Batteries do not belong in domestic waste.
• Dispose of batteries at the appropriate collection points.
• Do not open the computer. Failure to comply invalidates the warranty. You must not adjust or repair the
computer yourself or its correct function will no longer be guaranteed.
• This device is de signed to measure the blood pressure and pulse rate on upper arms of adults.
• This instrument is not intended for commercial or clinical use.
• Never immerse the blood pressure monitor in water or any other liquid.
• If you have further questions about using our devices, please contact your dealer.

Inserting the batteries

• Remove the battery cover from the back of the monitor.
Insert 4 alkaline-batteries, type AA, 1,5 V. making
absolutely sure that you insert them with the correct
polarity as marked. Never use rechargeable batteries.
• Replace the battery cover carefully. Now you can set the
date and time.
Setting date/ time
The date/ time setting is necessary, so that yu can save your readings correctly with the date and time
and call them up again later.
• First the year starts blinking. Press "M1" to increase numbers, or "M2" to decrease. Set the year accordingly
and confirm with the Start/Stop button.
• Using the "M1" and "M2" buttons, now enter the month. Confirm with the Start/Stop button.
• Now enter the day using the "M1" and "M2" buttons. Confirm with the Start/Stop button.
• Now you can set the time. This is displayed in 24-hour mode. First enter the hours, confirm with the Start/
Stop button and then enter the minutes. Once this is confirmed using the Start/Stop button, the device
automatically returns to normal time mode.

Changing batteries

If the battery change symbol „
measurement is still possible, the batteries should be replaced soon. If the battery change symbol „
is continuously illuminated, measurement is no longer possible and you must replace all the batteries. Once
batteries have been removed from the device, the time must be reset.
I N S T R U C T I O N S F O R U S E
" is blinking, the batteries are already too low. Even though
26
"