Ce Marking; Set-Up; Checking The Scope Of Delivery; Installation - Vaillant recoVAIR VAR 60/1 D Installation Instructions Manual

4 Set-up

Information on the
identification plate
Serial number

3.3 CE marking

The CE mark shows that the products
comply with the basic requirements of the
applicable guidelines as stated on the data
plate.
The manufacturer hereby declares that the
type of radio equipment that is described
in these instructions complies with Direct-
ive 2014/53/EU. The complete text for the
EU Declaration of Conformity is available
at: http://www.vaillant-group.com/doc/doc-
radio-equipment-directive/.
Frequency band: 868.0 – 868.6 MHz/2400 – 2496 MHz
Maximum transmission power:
< 25 mW/100 mW
4 Set-up

4.1 Checking the scope of delivery

▶
Check that the scope of delivery is com-
plete.
Quant- Contents
ity
1 Front panel
1 Wind protection
1 Wall-mounting frame
1 Fan unit
1 Regenerator with two filters
1 Operating instructions
1 Installation instructions
112
Meaning
The 7th to 16th digits
of the serial number
form the article num-
ber

5 Installation

5.1 Observing the requirements
for the product's installation
site
The product can be installed in flats, cellar
rooms, storage or utility rooms, and in at-
tics.
▶
Observe the current applicable national
construction regulations.
▶
Ensure that the installation site is dry
and is frost-proof throughout.
▶ When determining the installation loc-
ation, take into consideration the pro-
duct's sound power level and sound re-
duction index.
Technical data – General (→ Page 118)
▶
Take into consideration the diameter of
the pipe and the minimum clearances to
ceilings, windows and corners.
5.2 Installing the pipe from the
pre-installation set
1. Insert the pipe from the pre-installation
set into the designated position on the
external wall.
– In doing so, observe the set-up in-
structions that are enclosed with the
product.
2. Ensure that the power supply cable
and the control cable are not damaged
when you drill through the wall.

5.3 Installing the outer hood

▶ Install the outer hood and its wall-
mounting frame.
– In doing so, observe the set-up in-
structions that are enclosed with the
product.
– Use suitable rawl plugs and flat-head
screws.
Installation instructions recoVAIR 0020236694_03