Filling The Water Tank During Use; How To Make Cappuccino - Espressione Moka Aroma Espresso Manual

Warning!
Tighten well by turning it from left to right while making sure you have hooked it properly onto the flange
(Fig. 6).
If too much ground coffee is put inside the filter, turning the filter holder may prove difficult and/or you
may get leaks from the filter holder when the coffee is being dispensed.
Check that the steam function button (R) has not been unintentionally pressed.
It is advisable to let the filter holder heat up a few minutes in its seat before making a cup of coffee so that the
first cup is piping hot, too. This will not be necessary for the cups of coffee that follow.
To start dispensing, press the switch (S): the coffee will start coming out of the spouts of the filter holder. Press
the switch (S) again to stop it. The minimum serving of coffee is 50 ml.
Warning!
Like in professional coffee machines, do not remove the filter holder when the dispensing switch (S) is
on; danger of burns!
Warning!
Wait about ten seconds after the coffee has been dispensed before removing the filter holder; To re-
move it, turn it slowly from right to left so as to prevent splashes or spurts of water or coffee.
When the machine is in stand-by, the lamp (Q) will turn on and off periodically. This shows that the boiler
thermostat is tripping, which serves to keep the water temperature optimum.
When warming up, your appliance may release small puffs of steam from the filter holder; this is
perfectly normal.
It is a good idea to start dispensing the coffee only when this indicator lamp (Q) is off.
Remove the cup grill (B) to make coffee in a large cup (Fig. 8).
how to make coffee with a pod
To make coffee with pods you must use the specific pod filter (K) that came with the coffee maker as described
below:
1 Put the drip tray (L) and pod filter (M) inside the filter holder (K).
2 Place the pod in the filter (Fig. 16).
3 Push the pod towards the bottom of the filter with your fingers (Fig. 17).
4 The pod must be well centred and placed inside the filter.
5 Now it is possible to put the filter holder in its seat. Tighten the filter holder while making sure you have
hooked it properly onto the flange (Fig. 6).
6 The pod could remain stuck in the upper part of the machine after making the coffee and when removing filter
holder. To remove it, tilt the filter holder (Fig. 18) so the pod can fall onto it.
In order to always get an excellent cup of coffee, buy the pod that bears the E.S.E. compatibility mark.
if the pod is not inserted well, or if the filter holder is not tightened firmly, a few drops of water could
leak from the filter holder.

filling the water tank during use

No special operation is necessary when the water in the tank runs out because the machine has a special
self-priming valve. All you have to do is fill the tank with cool tap water up to the MAX level after unplugging it
from the socket-outlet. Pay close attention that the water does not dampen the switch area to prevent infiltra-
tions inside the electrical parts.

hoW to makE cappucciNo

To prepare a cappuccino or hot chocolate or to heat any other beverage, press the switch (R); the indicator
lamp (Q) turns on. When it turns off, the machine will be ready to generate steam.
When warming up, your appliance may release small puffs of steam from the filter holder; this is
perfectly normal.
Now open the steam dispensing cock (P) anti-clockwise, having the foresight to position a cup underneath
7