Troubleshooting Guide; Power Source - Canon EOS 1Ds Mark II Instruction Manual

Troubleshooting Guide

If there is a problem, first refer to this Troubleshooting Guide.

Power Source

The battery cannot be recharged.
¡
You are using the wrong battery.
s
Use the dedicated Ni-MH Pack. (p.18)
¡
The battery is not properly attached to the charger.
s
Attach the battery properly to the charger. (p.18)
The camera does not operate even when the < 4 > switch is set to < 1 >.
¡
The battery is exhausted.
s
Recharge the battery. (p.18)
¡
The battery is not installed properly.
s
Install the battery properly. (p.20)
¡
The memory card slot is open.
s
Push in the memory card and close the memory card slot. (p.24)
The access lamp lights or blinks even when the < 4 > switch is set to < 2 >.
¡
If you set the <
access lamp will still light or blink for a few seconds while the
image is recorded onto the memory card.
s
When the camera finishes recording the image to the memory
card, the access lamp will stop blinking and the power will turn off.
The battery becomes exhausted quickly.
¡
The battery is not fully charged.
s
Recharge the battery fully. (p.18)
¡
The battery's service life has expired.
s
Replace it with a new battery. (p.168)
162
4
> switch to <
2
> right after shooting, the