Page 14 of 290
Description
553-3001-105 Standard 5.00 June 1999
When installing line cards, these general procedures should be used:
— Configure the jumpers and switches on the line card (if any) to meet your
system needs.
— Install the line card into the slot you have selected.
— Install the cable that connects the backplane connector on the PE or IPE
module to the module I/O panel.
— Connect a 25-pair cable from the module I/O panel connector to the main
distribution frame (MDF).
— Connect the line card output to the selected terminal equipment at the
MDF.
— Configure the individual line interface unit using the Single-line
Telephone Administration program (LD 10) for analog line interface
units and Multi-line Telephone Administration program (LD 11) for
digital line interface units.
Once these steps have been completed, the terminal equipment is ready
for use.