Nortel NT1R20 Description page 204

Page 180 of 290
553-3001-105 Standard 5.00 June 1999
NT5D33 and NTRB34 Line-side E1 Interface Cards
Outgoing call DIAL BREAK RECEIVE - This is the value that the LEI
expects to see from the CPE during the break part of the digit. This value is
required.
Outgoing call ANSWERED SEND - This is the value that the LEI will
send to indicate that the distant end has answered the call. This value is
required.
Outgoing call (CPE) DISCONNECT RECEIVE - This is the value that
the LEI expects to see from the CPE when the customer equipment wishes to
end the call. This value is required.
Outgoing call (Distant End) DISCONNECT SEND - This is the value
that the LEI will send to indicate that the distant end has released the call This
value is required.
Disconnect Time - This is the number of milliseconds that the LEI will
send the disconnect signal to the CPE before reverting to the idle state. If the
CPE reverts to a connected state during this time, it will be ignored. This
value is only used when disconnect supervision is available and is needed for
the signaling type in use. It is used when the distant end initiates the
disconnect. For loop start cases, this value is not used.
Intercall (release guard) Time - This is the number of milliseconds that
the LEI will maintain the idle signal to the CPE before initiating a new call.
The CPE should not initiate a new call during this time, if it does so, the
off-hook indication will be ignored until the release guard time has expired.
This value defaults to 0 which relies on the M-1 to observe the proper guard
time. If a non-zero value is entered, off-hook from the CPE and Ringer-On
commands from the M1/SL100 will be ignored until this timer has expired.
Display Configuration (D C)
The Display Configuration (D C) command displays the various
configuration settings established for the LEI. Entering this command will
cause a screen similar to Figure 43 to appear: