Nortel NT1R20 Description page 201

Figure 41
Set Mode (S M): Table screen (Part One)
LEI:>S M
1) Default
2) Table
Hit <CR> to acce pt current value or type in a new one.
Current Mode : 1
Signaling Bits s et to Table.
Incoming and out going calls are in reference t o the CPE.
All ABCD bits ar e with respect to SENDing from LEI /M1 to CPE
or RECEIVing from C PE to LEI/M1.
Please enter new ABCD bits or hit <CR> to acce pt.
enter 2 or 4 val ues.
B bits will be c opied to the C and D bits.
IDLE SEND:
IDLE SEND bits c hanged to: 0101
IDLE RECEIVE:
IDLE RECEIVE bit s unchanged.
BLOCKING RECEIVE enabled? (Y/N): N
BLOCKING RECEIVE is disabled.
Incoming call RI NGER-ON SEND:
Incoming call RI NGER-ON SEND bits not changed.
Incoming call RI NGER-OFF SEND:
Incoming call RI NGER-OFF SEND bits not changed .
Incoming call OF FHOOK RECEIVE:
Incoming call OF FHOOK RECEIVE bits not changed .
Incoming call CO NNECTED SEND:
Incoming call CO NNECTED SEND bits not changed.
Incoming call (F ar End) DISCONNECT SEND:
Incoming call (F ar End) DISCONNECT SEND bits n ot changed.
Incoming call (C PE) DISCONNECT RECEIVE:
Incoming call (C PE) DISCONNECT RECEIVE not cha nged.
NT5D33 and NTRB34 Line-side E1 Interface Cards
New Mode : 2
If only 2 values are ent ered, the A and
Curr ent: 0000
C urrent: 0101
New: 0101
New:
Current: 0000
Current: 0101
Current: 1111
Current: 0101
Page 177 of 290
You may
New:
New: 0101
New: 11
New:
Curr ent: 1111
Curre nt: 0101
Line cards Description
New:
New: