Metabo C 60 Original Instructions Manual page 8

en ENGLISH
Keep your battery charger out of
reach of children!
Pull out the mains plug immediately
if the battery charger starts to
smoke or flames emerge!
Do not insert objects into the
ventilation slots on the battery
charger - there is a danger of
electric shocks and short circuits!
Do not use faulty battery packs.
5. Overview
See page 2.
1 Battery pack (not in scope of delivery)
2 Charging compartment
3 Operation display
4 Warning display
6. Commissioning
Before plugging in, check to see that the
rated mains voltage and mains
frequency, as stated on the rating label,
match with your power supply.
Devices such as this one, which generate direct
current, may have an effect on basic residual-
current circuit breakers. Use type F or better, with a
release current of max. 30 mA.
Before commissioning the charger, ensure
that the air slots are free. Minimum distance
to other objects is 5 cm.
6.1 Self-test
Insert mains supply plug.
The warning display (4) and the operating
indicator (3) light up in succession for approx.
1 second.
7. Use
7.1 Charging battery pack
Insert battery pack (1) up to the stop in the charging
compartment (2).
A battery pack that is new or has not been used for
some time only reaches full capacity after being
charged and discharged several times.
The operating indicator (3) flashes.
8
7.2 Conservation charge
Once the charging process has finished, the battery
charger automatically switches to conservation
mode.
The battery pack can remain in the battery charger
and is therefore always ready for use.
The operating indicator (3) lights up continuously.
8. Fault
8.1 Warning display (4) lights up
continuously
Battery pack is not charged. Excessive/Insufficient
temperature. When the temperature of the battery
pack is between 0 °C and 50 °C, the charging
process begins automatically.
8.2 Warning display (4) flashes
• Battery pack is defective. Remove the battery
pack immediately from the charger.
• The battery pack was not pushed correctly onto
the sliding seat (2). See section 7.1.
9. Repairs
Repairs to the charger must only be carried out by
qualified electricians.
If the mains connection cable of this tool is
damaged, in order to prevent endangering
personnel and property it must be replaced by the
manufacturer, or the Customer Service of the
manufacturer, or a similarly qualified person.
Contact your local Metabo representative if you
have Metabo chargers requiring repairs. For
addresses see www.metabo.com.
10. Environmental Protection
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Directive 2002/
96/EC relating to electric and electronic machines
and implementation in national law, used electric
tools must be collected separately and disposed of
in an environmentally friendly manner at recycling
centres.