Dmx Linking - Chauvet DJ Intimidator Scan 360 Quick Reference Manual

AC Power
This product has an auto-ranging power supply that works with an input voltage range of 100 to 240 VAC, 50/60 Hz.
To eliminate wear and improve its lifespan, during periods of non-use completely disconnect the
product from power via breaker or by unplugging it.
Power Linking
For the maximum number of Intimidator Scan 360 products that you can power link at each voltage, see the User Manual
or the sticker on the product.
Fuse Replacement
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap and replace with a fuse of the exact same
type and rating.
5. Re-insert the fuse holder and reconnect power.
Mounting
Before mounting this product, read the
Mounting Diagram
Safety cable
pass-through

DMX Linking

The Intimidator Scan 360 can work with a DMX controller. Instructions for connecting and configuring this product for DMX
operation are in the User Manual. If you are not familiar with DMX, download the DMX Primer from www.chauvetdj.com.
Starting Address
To ensure full access to all channels available in each DMX mode, the highest recommended DMX address is 501.
Master/Slave Connection
The Intimidator Scan 360 uses the DMX data connection for its Master/Slave mode. Information about configuring the
Intimidator Scan 360 for Master/Slave operation is in the User Manual, which is available from the Chauvet website.
IRC-6 (Infrared Remote Control)
The Intimidator Scan 360 can be operated with the CHAUVET IRC-6. For more information about the IRC-6, download
instructions for the IRC-6 or the Intimidator Scan 360 User Manual from www.chauvetdj.com.
Intimidator Scan 360 QRG Rev. 2
QUICK REFERENCE GUIDE
Safety Notes.
(such as CLP-10 from Chauvet)
Safety cable
(such as CH-05 from
Mounting bracket
Mounting clamp
Chauvet)
EN
2