Adjusting The Wheel; Using The Scale Master Classic; Rolling" A Measurement - Calculated Industries SCALE MASTER CLASSIC 6020 User Manual

Adjusting the Wheel

To adjust the Celcon
a small, flat-head jeweler's screwdriver
and slightly rotate the screw near the wheel
tip. Rotating the screw between 1 ⁄4 to 1⁄ 3
turn should adjust the wheel between free
spinning (which is too loose) to skidding
(which is too tight).
U
SING THE

"Rolling" a Measurement

To take a measurement with the Scale
Master Classic:
Switch the unit on. Press [Reset] to clear
1)
the display.
2) Select your scale mode by pressing the
[Mode] key. Then press the [Scale] key
to select your scale.
3) Begin rolling. The display will register
your measurements.
To ensure accurate measurements, be
sure to hold the unit upright and start
and stop the SMC at the exact points
you are measuring.
4) Press the appropriate key if you want
to store this measurement (ex. [M1+]
to store as length, [M2x] to store as
width).
Press [Reset] to clear the display and
5)
begin a new measurement.
polymer wheel, take
®
S M
CALE
C
®
ASTER
5 – User's Guide
LASSIC