IKEA NUTID HGA4K Manual page 13

ENGLISH
- loosen screw to increase the flame height
(+).
The adjustment must be performed with the
tap in minimum gas setting position (small
flame ) .
- The primary air of the burners does not
need to be adjusted.
- At this stage, light up the burners and
turn the knobs from max position to
minimum position
stability.
Upon completion of adjustment, reseal
the work surface using sealing wax or an
equivalent material.
GB
REFERENCE TO LOCAL
REGULATIONS
Provision for ventilation
The room in which the appliance is installed
must have an air supply to current B.S. 5440
- Part 2 standards.
All rooms require a permanent vent in
addition to the openable window.
If there are other fuel burning appliances in
the same room B.S. 5440 - Part 2 should
be consulted to determine the air vent
requirements.
to check flame
If the appliance is installed in a cellar or
basement, it is advisable to provide an
air vent of 65 cm, irrespective of the room
volume.
Gas Safety Regulations
The law requires that all gas appliances
are installed by competent persons in
accordance with the current gas safety
regulations. Failure to install appliances
correctly may lead to prosecution.
It is in your own interest, and that of safety,
to ensure that the law is complied with.
The hob should be installed in accordance
with the Gas Safety (Installation and Use)
Regulations, the Building Regulations
issued by the Department of the Environment
and the Building Standard (Scotland)
(Consolidation) Regulations, issued by the
Scottish Development Department.
In the G.B., CORGI registered installers work
to safe standards of practice.
13