ENGLISH Contents Safety information Care and cleaning Safety Instructions Troubleshooting Product description Technical information Daily use Installation Hints and tips Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages.
ENGLISH General Safety The appliance and its accessible parts become hot during • use. Do not touch the heating elements. Do not operate the appliance by means of an external timer • or separate remote-control system. Unattended cooking on a hob with fat or oil can be •...
Page 6
ENGLISH • Always be careful when you move the appliance or hot cookware, when you appliance because it is heavy. Always connect the appliance to the near wear safety gloves. sockets • Seal the cut surfaces with a sealant to •...
Page 7
ENGLISH appliance according to current • Do not keep hot cookware on the control installation regulations. Pay attention to panel. requirements regarding adequate • Do not let cookware to boil dry. ventilation. • Be careful not to let objects or cookware fall on the appliance.
ENGLISH • Clean the appliance with a moist soft • Contact your municipal authority for cloth. Only use neutral detergents. Do information on how to discard the not use abrasive products, abrasive appliance correctly. cleaning pads, solvents or metal objects. •...
ENGLISH Daily use Warning! Refer to Safety If after a few attempts the burner chapters. does not ignite, check that the crown and its cap are in correct Burner overview positions. Warning! Do not keep control knob pressed for more than 15 seconds.
ENGLISH Turning the burners off Warning! Always turn the flame down or switch it off before To put the flame out, turn the relevant removing the pans of the burner. control knob to the symbol Hints and tips Warning! Refer to Safety Burner minimum maximum...
ENGLISH After cleaning, be sure to wipe dry with a The pan supports are not soft cloth. dishwasher proof, they must be washed by hand. After cleaning, make sure that the pan supports are correctly positioned. Periodically ask the After Sales Service to check the conditions of the gas supply pipe and the pressure adjuster, if it is fitted...
ENGLISH If you operated the appliance wrongly, or the installation was not carried out by a registered engineer, the visit from the customer service technician or dealer may not take place free of charge, even during the warranty period. Technical information Hob dimensions width 580 mm...
ENGLISH Installation Warning! Refer to Safety Warning! The appliance must be chapters. earthed! Warning! Risk of injury from General information electrical current. Warning! This appliance must be • The electrical mains terminal is live. installed, connected or repaired • Make electrical mains terminal free of only by a registered competent voltage.
Page 15
ENGLISH power rating (refer to the Technical Gas connection information chapter). Warning! Only a qualified The plug has to be fitted in a proper socket. person must install this If connecting the appliance directly to the appliance. electric system, it is necessary that you install a double pole switch between the Warning! This appliance is not appliance and the electricity supply, with a...
Page 16
ENGLISH To replace injectors: 1. Remove pan support. 2. Remove burner cap and crown. 3. With a socket spanner 7 unscrew and remove the injectors, replace them with the ones required for the type of gas in use. 4. Reassemble the parts, following the same procedure backwards.
Page 17
ENGLISH 2. Set the gas tap to the minimum flame (diameter 10 mm, in following figure) position then turn the control knob from on, included in the supply (primary air minimum to maximum several times. If regulators) ; the flame is unstable or extinguished, •...
Page 18
ENGLISH the ones required for the type of gas in • For G20 (2H) 25 mbar turn the use. bypass screw 1/2 of a turn 4. Reassemble the parts, following the clockwise. same procedure backwards. • For G30/G31 (3B/P) 30/30 mbar tighten the bypass screw fully and To adjust the minimum level of the burners: undo approximately 1/2 of a turn.
Page 19
0900 235 45 32 ma - vr 08.00 - 20.00, 15 cent/min., starttarief 4.54 cent Nederland and/or zat 09.00 - 20.00 en gebruikelijke belkosten 0900 BEL IKEA (zondag gesloten) Norge 815 22052 Takst innland 8 til 20 ukedager Österreich 0810 300486 max.
Need help?
Do you have a question about the Lagan HGA4K and is the answer not in the manual?
Questions and answers