Eiki lc-xip2600 Interactive Functions Manual page 26

Hide thumbs Also See for lc-xip2600:

Troubleshooting

(3) The image resolution has been changed.

Running the calibration procedure again will solve the problem.

4. Q: Why is the cursor jumping?

A: This may be caused by strong ambient light interference. Try to avoid

strong ambient light interference, especially strong sun light directly

projected on the screen. (Please refer to the Question 2.)

5. Q: Why is the LightPen not working after the computer wakes up

from standby?

A: In some cases, if the computer goes into standby mode, the computer

will shut the USB port. In such case, please wake up computer,

unplug and insert the USB cable again. (Please refer to the Question

1.)

6. Q: Why does the window screen appear "Strong lighting in the

environment may cause light pen to stop functioning normally."

A: It is because the ambient light is too strong. The light is shown white

in the window. Please take off the light out of the sensor's site by

moving the screen or turning off the light or using curtains etc..

Table of Contents