Table of Contents
Advertisement
3. Using your finger, pull the lever towards you and
unhook it from the window frame bracket.
4. Gently pull the top of the window outward. Lift
the window out of its bottom railing and set it
aside in a safe place to avoid damage.
WARNING: A barrier designed to reduce the risk of burns from the hot viewing glass is provided with this
appliance and shall be installed for the protection of children and other at-risk individuals. If the barrier becomes
damaged, the barrier shall be replaced with the manufacturer's barrier for this appliance. Only doors certified
CAUTION: Consider the height of hearth finish material when building a platform. Proper installation of safety
barriers with an overlap fit design require the bottom of the appliance to be level with finished hearth. For
installation instructions refer to "Safety Barrier Installations".
Certified Safety Barriers
WARNING: If burner and/or pilot have been burning, use appropriate protection to avoid burns or damage
to personal property before removing any components. DO NOT OPERATE THIS APPLIANCE WITHOUT THE HEAT
SHIELDS (LOCATED OVER THE CONTROL BOARD AND VALVE) IN PLACE. IF GASKETING IS DAMAGED, IT MUST BE
CAUTION: Check all connections for leaks with soapy water, whether field or factory made.
ELECTRICAL SPECIFICATIONS
This appliance, when installed, must be electrically grounded in accordance with local codes, or in the absence
of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.1.
WIRING REQUIREMENTS
• The Ignition Module requires 120V of electricity and/or batteries to operate.
• Using the battery back-up will operate the burner only.
• Optional fan and light components will not function on battery back up power.
WARNING: Do not use this fireplace if any part has been under water. Immediately call a qualified service
technician to inspect this appliance and to replace any part of the control system and any gas control which
WARNING: Electrical Grounding Instructions: This appliance is equipped with a three-prong (grounding) plug
for your protection against shock hazard and should be plugged directly into a properly grounded three-prong
receptacle. Do not cut or remove the grounding prong from this plug.
Safety Barrier Information
with the appliance shall be used.
Do not operate this appliance without a safety barriers. Only safety barriers certified
with the appliance shall be used.
Control Board
REPLACED.
Electrical Information
has been under water.
-18-
Advertisement
Table of Contents
