Table of Contents
Advertisement
OWNER'S OPERATION AND INSTRUCTION MANUAL
BRECKWELL
US ENVIRONMENTAL PROTECTION AGENCY PHASE II CERTIFIED WOODSTOVE
THIS MANUAL WILL HELP YOU TO OBTAIN EFFICIENT, DEPENDABLE SERVICE FROM THE HEATER, AND ENABLE
YOU TO ORDER REPAIR PARTS CORRECTLY. KEEP IN A SAFE PLACE FOR FUTURE REFERENCE.
French version is available for download from the Breckwell website: http://www.breckwell.com/
La version française est disponible pour téléchargement à partir du site Breckwell: http://www.breckwell.com/
Breckwell
P.O. Box 750
Bridgeport, AL 35740
Phone: (866) 606-8444
www.BRECKWELL.com
Exceptional Heat, Outstanding Value
MODEL: SW940
Approved for installation in the USA and Canada
SAFETY TESTED TO UL 1482-2011, ULC-S627-2000 and ULC-S628
WASHINGTON STATE APPROVED
SAVE THESE INSTRUCTIONS
Please read this entire manual before you install or use
your new room heater. Failure to follow instructions may
result in property damage, bodily injury, or even death.
Improper Installation Could Void Your Warranty!
SAFETY NOTICE:
If this heater is not properly installed, a house fire may
result. For your safety, follow the installation instructions.
Never use make-shift compromises during the installation of this
heater. Contact local building or fire officials about permits,
restrictions and installation requirements in your area.
CAUTION!
®
852080
Advertisement
Table of Contents
Related Manuals for Breckwell SW940
Summary of Contents for Breckwell SW940
- Page 1 YOU TO ORDER REPAIR PARTS CORRECTLY. KEEP IN A SAFE PLACE FOR FUTURE REFERENCE. French version is available for download from the Breckwell website: http://www.breckwell.com/ La version française est disponible pour téléchargement à partir du site Breckwell: http://www.breckwell.com/ Breckwell P.O. Box 750...
- Page 2 DO NOT LEAVE THE STOVE UNATTENDED WHEN THE DOOR IS SLIGHTLY OPENED. DO NOT BURN GARBAGE, FLAMMABLE FLUID SUCH AS GASOLINE, NAPHTHA OR MOTOR OIL. DO NOT CONNECT TO ANY AIR DISTRIBUTION DUCT OR SYSTEM. ALWAYS CLOSE THE DOOR AFTER THE IGNITION. Breckwell...
-
Page 3: Pre-Assembly
A power drill with an 1/8” drill bit to install sheet metal screws into connector pipe. Sheet metal screws A non-combustible fl oor protector as specifi ed in this manual All chimney and chimney connector components required for your particular venting installation. Breckwell... -
Page 4: Free Standing Assembly
4) Make sure that the baffl e board, above the air tubes, is in place and undamaged. DO NOT remove the baffl e board. If an outside combustion air source is needed see the “Combustion Air Assembly Instructions” section in this manual. Breckwell... - Page 5 INSERT FIREPLACE FACADE ASSEMBLY Breckwell Room Heaters are available as an insert into existing masonry or factory-built fi replaces. Do not alter the existing fi replace in any way either by removing bricks or mortar which could weaken the structural integrity of the fi...
-
Page 6: Positioning The Stove
• A fl ue pipe crossing a combustible wall must have a minimum Ceiling Height 2133 clearance of 18” (457.2mm). Backwall to Flue • To reduce fl ue clearances from combustible materials, contact Sidewall to Flue your local safety department. Wall to Flue (Angled Installation) Breckwell... -
Page 7: Clearances To Combustibles
For UL Listed fl oor protectors, refer to manufacturers instructions for installation directions. Dimension Inch Stove Width Stove Depth L ⃰ ⃰ Front Back N ⃰ ⃰ Left P ⃰ ⃰ Right ⃰ Canadian installations require 18” (457mm) ⃰ ⃰ Canadian installations require 8” (203mm) Breckwell... - Page 8 First using a pair of pliers or other means, remove the metal plate from the back of the pedestal and bend the tabs out. Follow the manufacturer’s installation instructions for attaching the dryer vent kit to the home. Then attach it to the appliance. Breckwell...
- Page 9 The draft caused by the tendency for hot air to rise will be increased with an interior chimney. • Using a fi re screen at the extremity of the chimney requires regular inspection in order to insure that it is not obstructed thus blocking the draft, and it should be cleaned when used regularly. Breckwell...
-
Page 10: Installation Into A Masonry Fireplace
INSTALLATION INTO A MASONRY FIREPLACE: Breckwell recommends the use of a full liner where a stainless steel rigid or fl exible linear pipe is routed from the insert outlet collar to the top of the chimney. Multiple installation methods may be available in your area. Check with local building offi cials for any permits required for installation of this unit and notify your insurance company before proceeding with installation. -
Page 11: Masonry Chimney
Make sure there are no cracks, loose mortar or other signs of deterioration and blockage. Have the chimney cleaned before the stove is installed and operated. When connecting the stove through a combustible wall to a masonry chimney, special methods are needed as explained in the “Combustible Wall Chimney Connector Pass-Throughs” Section. Breckwell... -
Page 12: Combustible Wall Chimney Connector Pass-Throughs
Connectors to a masonry chimney, excepting method B, shall extend in one continuous section through the wall pass-through system and the chimney wall, to but not past the inner fl ue liner face. A chimney connector shall not pass through an attic or roof space, closet or similar concealed space, or a fl oor, or ceiling. Breckwell... -
Page 13: Chimney Connector (Stove Pipe)
Installation of a “barometric draft stabilizer” (fi replace register) on a smoke exhaust system is prohibited. Furthermore, installation of a draft damper is not recommended. With a controlled combustion wood stoves the draft is regulated upon intake of the combustion air in the stove and not at the exhaust. Appliance Breckwell... -
Page 14: Factory Built Chimney
fl ashing, chimney cap, etc. Maintain proper clearance to the structure as recommended by the manufacturer. The chimney must be the required height above the roof or other obstructions for safety and proper draft operation. Breckwell... -
Page 15: Testing Your Wood
If your wood hisses and water or vapor escapes at the ends of the piece, your wood is soaked or freshly cut. Do not use this wood in your oven. Large amounts of creosote could be deposited in your chimney, creating potential conditions for a chimney fi re. Breckwell... -
Page 16: The First Fires
Once the updraft movement is initiated, you are ready to ignite the stove by lighting the paper and kindling wood inside the combustion chamber. When you have achieved a good bed of hot embers, we recommend the following burn procedures: SW940 Primary Air Settings Electric Blower Speed Setting (Variable) (Slide Damper is located in center of stove under hearth plate) (Blower is on High when turned “ON”,... -
Page 17: Ash Disposal
• THE ASH PAN CAN BECOME VERY HOT. WEAR GLOVES TO PREVENT INJURY. • NEVER BURN THE STOVE WITH THE ASH TRAP OPEN. THIS WOULD RESULT IN OVER FIRING THE STOVE. DAMAGE TO THE STOVE AND EVEN HOUSE FIRE MAY RESULT. Breckwell... -
Page 18: Maintenance
1200° F heat resistant paint. For this purpose, simply scrub the surface to be repainted with fi ne sand paper, clean it properly, and apply thin coats (2) of paint successively. Breckwell... -
Page 19: Repair Parts List
REPAIR PARTS LIST Breckwell... -
Page 20: Repair Parts Diagrams
REPAIR PARTS DIAGRAMS Breckwell... - Page 21 Breckwell...
-
Page 22: How To Order Repair Parts
When ordering repair parts, always give the following information as shown in this list: The part number ___________________________________________ The part description ___________________________________________ The model number: ___________________________________________ The serial number:___________________________________________ Breckwell P.O. Box 750 Bridgeport, AL 35740 Phone: (866) 606-8444 www.BRECKWELL.com... - Page 23 You may use an envelope if you choose. You may register online by going to www.breckwell.com All information submitted will be kept strictly confi dential. Information provided will not be sold for advertising purposes.
- Page 24 Fold Here Fold Here Fold Here PLACE STAMP HERE Breckwell P.O. Box 750 Bridgeport, AL 35740 Breckwell...