Setting An Indoor Unit Address And Installation Option - Samsung AC018KN4DCH Service Manual

4. Troubleshooting

4-1 Setting an indoor unit address and installation option

▶ Set the indoor unit address and installation option with remote controller option.
Set the each option separately since you cannot set the ADDRESS setting and indoor unit installation setting option at thesame time.
You need to set twice when setting indoor unit address and installation option.
4-1-1. The procedure of setting option
▶ MR-EC00 and MR-EH00 remote controls
Entering the
mode for setting
the options
High Temp button
Low Temp button
Enter the mode for setting the options
Step 1
1. Enter the mode for setting the options :
a. Remove the batteries from the remote control,and then insert them again.
b. While holding down the
c. Make sure that you are entered to the mode forsetting the options:batteries into the remote control.
2. Set the option values.
CAUTION
set values for these options are skipped automatically.
SEG6 and SEG8
SEG20 SEG21 and SEG22
SEG1 SEG2
0 X
SEG13 SEG14
2 X
(High Temp) and (Low Temp) buttons simultaneously, insert thebatteries into the remote control.
SEG9 and SEG10 SEG11 andSEG12
SEG23 and SEG24
SEG3 SEG4 SEG5 SEG6
X X X X
SEG15 SEG16 SEG17 SEG18
X X X X
Mode button
High Fan button
Low Fan button
SEG14 and SEG15
SEG7 SEG8 SEG9 SEG10
1 X X X
SEG19 SEG20 SEG21 SEG22
3 X X X
4-1
Setting the
option values
SEG4 and SEG5
SEG16 and SEG17 SEG18 and
SEG11 SEG12 On (SEG1~12)
X X
SEG23 SEG24
X X
Off (SEG13~24)