Samsung AC018KN4DCH Service Manual page 46

Troubleshooting
Check the option you have set
Step 2
Check whether the option values that you have set are correct by pressing the
[SEG2, SEG3]
[SEG11, SEG12]
[SEG21, SEG22]
Save the option values into the indoor unit
Step 4
Point the remote control to the remote control sensoron the indoor unit and then press the
sure that this command is received by the indoor unit; if it is notreceived, press the
Check whether the air conditioner operates in accordance with the option values you have set
Step 5
1. Reset the indoor unit by disconnecting and then reconnecting the power cable of the indoor unit or by pressing the RESET
button on the outdoor unit.
2. Remove the batteries from the remote control,insert them again, and then press the
[SEG4, SEG5] [SEG6, SEG8]
[SEG14, SEG15] [SEG16, SEG17]
[SEG23, SEG24]
4-6
(Mode) button repeatedly
[SEG9, SEG10]
[SEG18, SEG20]
(Power)button on the remote control. Make
(Power) button again.
(Power) button on the remote control.