Jayco Embark 2022 Owner's Manual page 128

Section 10: Appliances
Use a vacuum cleaner with a soft brush to clean the grille, the open areas behind
the grille and the front surface area of the condenser.
Replace the base grille when finished.
Cleaning the Exterior
Painted metal exteriors: wash with a clean sponge or soft cloth and a mild detergent in
warm water.
Stainless steel exteriors: wash with a clean sponge or soft cloth and a mild detergent in
warm water. Do not use appliance wax, polish, bleach, or other products containing chlorine
on stainless steel. Stainless steel can be cleaned with a commercially available stainless
steel cleaner. A spray-on stainless steel cleaner works best.
IMPORTANT: Do not allow the Stainless Steel Cleaner and Polish to come into con-
tact with any plastic parts such as the trim pieces, dispenser covers or door gaskets.
If unintentional contact does occur, clean plastic part with a sponge and mild detergent in
warm water. Dry thoroughly with a soft cloth.
For silver-accented plastic parts, wash with soap or other mild detergents. Wipe clean with
a sponge or damp cloth. Do not use scouring pads, powdered cleaners, bleach or cleaners
containing bleach as these products can scratch and weaken the paint finish.
Portable Chest Cooler (if so equipped)
The following is an overview of the portable chest cooler. For complete details on features,
operation, other safety information, and troubleshooting, refer to the manufacturers user's
guide found in your warranty packet.
NOTE: Before using your cooler for the first time, and occasionally after
use, clean the inside and outside using a damp cloth.
Never clean the cooler under running water or in dish water.
Do not use abrasive cleaning agents or hard objects during cleaning as
these can damage the cooler.
Never use brushes, scouring pads or hard or pointed tools to remove ice
or to loosen objects which have frozen in place.
Always pull out the main plug before you clean and service the cooler.
Manufacturer recommends against the use of an extension cord because
of potential safety hazards. However if you must use one it MUST be
UL or CSA listed with a 10Amp (minimum) 120VAC electrical rating.
Refer to the table in the manufacturer's user guide (in your warranty
packet) for a chart on selecting an extension cord.
ALWAYS uncoil and extension cord to avoid heat retention and possible
melting.
DO NOT use power strips or 2 way splitters.
Under NO CIRCUMSTANCES should you attempt to splice extension
cord wires.
The following guidelines should be followed to assure you are getting the maximum perfor-
mance from your cooler:
122
Maintenance Record Table of Contents