Avid Technology Pro Tools SYNC X Manual page 4

Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other.
A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If
the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
For products containing a lithium battery:
15
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
CAUTION!
Danger d'explosion si la batterie est mal remplacée. Remplacer uniquement par le même type ou le même type.
ATTENTION!
For products with a power switch: It should remain accessible after installation.
16
The equipment shall be used at a maximum ambient temperature of 40° C.
17
This unit is provided with a power supply cord set suitable for 120V AC input only (for U.S.A. and Canada). For other than U.S.A.
18
and Canada, a qualified person must provide for use with this unit, an appropriate, approved power supply cord set which is in com-
pliance with the end use country requirements and has a minimum cross-sectional area of 1.0mm2.
For products with more than one power cord:
19
This unit has more than one power supply cord. Disconnect two power supply cords before servicing to avoid electrical
CAUTION:
shock.
Cet appareil comporte plus d'un cordon d'alimentation. Afin de prévenir les chocs électriques, débrancher les deux cor-
ATTENTION:
dons d'alimentation avant de faire le dépannage.
For products with an operator-accessible fuse:
20
For continued protection against risk of fire, replace only with same type and rating of fuse.
CAUTION:
Pour ne pas compromettre la protection contre les risques d'incendie, remplacer par un fusible de même type et de même
ATTENTION:
caractéristiques nominales.
Rack-Mount Safety Instructions
Elevated Operating Ambient—If installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack en-
1
vironment might be greater than room ambient. Therefore, consider installing the equipment in an environment compatible with the
maximum ambient temperature (Tma) specified by the manufacturer.
Reduced Air Flow—Installation of the equipment in a rack should be such that the amount of air flow required for safe operation of
2
the equipment is not compromised. Make allowances for cooling air to be available to the front panel surface and no restrictions at
the rear.
Mechanical Loading—Mounting of the equipment in the rack should be such that a hazardous condition is not achieved due to un-
3
even mechanical loading.
Circuit Overloading—Consideration should be given to the connection of the equipment to the supply circuit and the effect that over-
4
loading of the circuits might have on over-current protection and supply wiring. Appropriate consideration of equipment nameplate
ratings should be used when addressing this concern.
Reliable Earthing—Reliable Earthing of rack-mounted equipment should be maintained. Particular attention should be given to sup-
5
ply connections other than direct connections to the branch circuit (for example, use of power strips).
LED Safety Notices
Avid hardware might contain LED or Laser devices for communication use. These devices are compliant with the requirements for
Class 1 LED and Laser Products and are safe in the intended use. In normal operation the output of these laser devices does not exceed
the exposure limit of the eye and cannot cause harm.
Pro Tools | Sync X Guide iv