Samsung Electronics DVM Series Technical Manual page 35

ΙΙ
. Control System
4. Installation
(3) Setting up option switches
Indoor unit PCB
1) Adjust K1 DIP switch(SW03) on the PCB to the "OFF"
position.
2) Turn the arrow of RMC rotary switch(SW01) to the
appropriate position.
Result : It is controlled by a wired remote controller which has
the same address.
Wired remote controller PCB
1) Assign an address to the wired remote controller by turning
the arrow of rotary switch.
N N o o t t e e The address of wired remote controller and the RMC
N N o o t t e e
address of indoor units should be the same.
2) Adjust the DIP switch to appropriate position.
Refer to the table below.
Switch No.
1
2
3
4
All indoor units you wish to control with wired remote controller must have the same RMC address.
Indoor units controlled with the same wired remote controller should be connected to the same
outdoor unit and must have different MAIN addresses.
If you would like to use the wired remote controller and the centralized controller together,
refer to page ΙΙ-14.
OFF
Cooling only
-
°C display
Can be used wired and
wireless remote controller
(Slave mode)
ΙΙ
10
SW03
RMC
Rotary
Switch
ON
Cooling and Heating
-
°F display
Can be used wired remote
controller only
(Master mode)
K1 K2 K3 K4
SW01
DIP Switch
Original Position
ON
OFF
OFF
OFF