Wired Remote Controller - Samsung Electronics DVM Series Technical Manual

4-2. Wired remote controller

(1) Accessories
Wired Remote Cable-Tie(2)
Controller (1)
(2) Installation
1) Open the wired remote controller by using two grooves on
its top.
2) Secure the rear cover of the wired remote controller on the
wall with 2 screws.
3) Connect each F1, F2, V1, and V2 terminal on the wired
remote controller PCB to the indoor unit.
4) Reassemble the wired remote controller.
5) In case of 1-way Cassette type, connect terminals with the
main PCB of indoor unit as shown at the figure.
N N o o t t e e Be careful about the cables so that they will not be mixed up.
N N o o t t e e
AC Power
supply
White
The wired remote controller must be installed by an installation specialist.
Before installing the wired remote controller, ensure that you have turned off the main power.
All wired remote controller cables should be installed according to the
national wiring rules and you must install it in the wall not to be touched by users.
Cable Clamp M4x16
(5) Tapped Screw
(7)
Main PCB of indoor unit
CN43(White)
Black
ΙΙ
9
Indoor Unit Owner's
Power Drawing instructions(1)
Cable (1)
Installation
manual (1)
Wired remote
controller PCB