ADTRAN NetVanta Series Quick Configuration Manual page 8

Table of Contents

Equipment Required1
Network Diagrams1
Configure The Unit2
Initiate A Console Session2
Configure The Ethernet Port Parameters2
Begin The E1 Network Interface Configuration3
Create The E1 Interface Tdm Group3
Configure The G.703 Interface (Optional)4
Configure The Frame Relay Virtual Interface4
Create The Pvc And Assign An Ip Address4
Configure The Virtual Ppp Interface5
Create The Cross-Connect5
Configure Static Routes5
Configure Dynamic Routes6
Set The Enable Security Mode Password6
Configure Telnet Access7
Save The Configuration7
Complete The Installation7