Initial Set-Up & Coffee Brewing - Bunn CDBC Operating & Service Manual

1. Insert an empty funnel into the funnel rails.
2. Place an empty decanter under the funnel.
3. Connect the brewer to the power source.
4. Model CDBC – Press the "ON/OFF" switch (indicator glowing).
Model SINGLE CD - Press the "1 gal" switch (indicator glowing) and the "ON/OFF" switch (indicator glowing).
5. Water will flow into the tank and stop when the tank is filled to its capacity.
6. Wait approximately twenty minutes for the water in the tank to heat to the proper temperature.
7. To remove expansion water, place a small vessel beneath the faucet and open the faucet handle. Release it
when you hear the tank refilling. If brewer is not equipped with a faucet, place a empty decanter beneath the
funnel and initiate a brew cycle.
8. Place an empty decanter/server beneath the funnel and press the "ON/OFF" switch (indicator glowing) then
momentarily press and release the "BREW" switch.
Allow the cycle to finish and measure the amount of water in the decanter/server. It should be 64 ounces ±
9.
2 for CDBC models and 128 ounces ± 2 for SINGLE CD models. Refer to the adjustments section of this manual
should the volume need to be increased or decreased.
10. Model SINGLE CD only press the "1/2 gal." switch, place an empty server beneath the funnel and press and
release the "BREW" switch. Allow the cycle to finish and measure the amount of water in the server. It should
be 64 ounces ± 2. Refer to the adjustments section of this manual should the volume need to be increased
or decreased.
The brewer is now ready for use in accordance with the coffee brewing instructions below.
®
1. Insert a BUNN filter into the funnel.
2. Pour fresh coffee grounds into the filter and level the bed of grounds by gently shaking.
3. Slide the funnel into the funnel rails.
4. Place an empty decanter/server beneath the funnel.
5. Model CDBC – Press the "ON/OFF" switch (indicator glowing) then momentarily press and release the "BREW"
switch.
Model SINGLE CD - Select 1/2 or 1 Gallon setting then momentarily press and release the "BREW" switch.
6. When brewing is completed, simply discard the grounds and filter.
INITIAL SET-UP
COFFEE BREWING
Page 6 35582 041503