Pour-Over Feature; Cleaning - Bunn CDBC Operating & Service Manual

If the brewer is equipped with a pour-over feature, follow the instructions below.
1. Remove the thumbscrew and pour-in lid from the top cover of the brewer and set aside.
2. Insert a BUNN ® filter into the funnel.
3. Pour fresh coffee grounds into the filter and level the bed of grounds by gently shaking.
4. Slide the funnel into the funnel rails.
5. Place an empty decanter beneath the funnel.
6. Measure 64 ounces of cold water in a container and slowly pour the water into the pour-in opening.
NOTE: When using pour-over feature to brew a 1 gal. batch, pour in 64 ounces of cold water and wait
until drip out of funnel is complete then pour in 64 more ounces of cold water.
7. Press the ON/OFF button to activate the lower warmer (Indicator lamp on).
NOTE: Do not press the Brew Button. It is not necessary when using the pour-over feature.
8. When brewing is completed, simply discard the grounds and filter.
1. The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all
surfaces on Bunn-O-Matic equipment.
2. Check and clean the sprayhead. The sprayhead holes must always remain open.

POUR-OVER FEATURE

Models CDBCP & CDBCFP

CLEANING

Page 7 35582 041503