Tm Compressor - Pari SinuStar Instructions For Use Manual

Transport/Storage Range:
Ambient Temperature:
Relative Humidity:
Atmospheric Pressure:
Explanation Of Symbols:
ON/OFF
_____________________________________________________________________
VII. Maintenance Of The SinuStar
Tubing Maintenance:
If there is any moisture or condensation in the tubing after the treatment,
let the compressor run with only the tubing attached for a few minutes. The
warm air from the compressor will dry the moisture or condensation in the
tubing. Use a damp cloth to wipe the exterior of the tubing.
Filter:
The Clear View™ Filter on the front of the SinuStar
designed to be monitored without removing it. This makes it easy to check
without much work. When the filter is new, it is bright white in color. Over
time, the filter will turn grey, which means it is time to replace it. You must
also replace the filter if it gets wet or becomes clogged. There is no reason
to remove the filter until you are ready to replace it. The filter is rated to last
500 hours of use before replacement is required. A good general rule is to
replace the filter whenever you replace your SinuStar
English
7
________________________
10% to 100%, including condensation
______________________
____________________________________
-40°C to 70°C, (-40°F to 158°F)
500 hpa to 1060 hpa
TM
Compressor
TM Compressor was
TM Reusable Nebulizer.