Advertisement
On the right outer corner, there is a connection for the electricity plug. It is important to make sure that
the electricity plug is completely plugged in, to allow the incubator to work accordingly. As soon as the
plug is connected, the incubator will turn on.
Besides the display (1), there are three more buttons with which the incubator is operated (see section
"explanation of the function buttons") and two small lamps which will glow when the heater is
warming up ("work") or adjustment settings are being made ("set").
The display shows the temperature in degrees Celsius.
Explanation of the Function Buttons (incubator 51073)
The incubator has three buttons, which are required for the operation of the incubator. The buttons
and their possible combinations will be explained in the following paragraph. Before operating the in -
cubator, ensure that it is properly plugged into the according area.
The buttons are positioned the following from left to right (green and round) in the centre of the operat-
ing panel: "set", "+" and "-".
0. Set: This button allows to set the basic temperature of the incubator.
Press the button once: adjusting the basic temperature (parameter ID: PP).
By selecting the "+" and "–" button, you can set the desired temperature, pressing the
"set" button again will save the entered value.
The preset temperature is 37.8
2.
"Set" and "+": Pushing both at the same time opens the menu for the finer parameter
settings (see table 1).
The display will show the individual parameter, displayed as a number-letter combina-
tion (parameter ID).
With the "+" and "–" buttons, you can choose between the individual parameters.
If you wish to alter a parameter, push the "set" button and alter the shown value with
"+" or "–" up or downward.
Pushing the "set" button will save the changes.
Finer para-
Parameter
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
℃
.
Adjustment
Standard
Item 51073, 51269
Note
Page 9
12
2020-1
Advertisement
