Advertisement
meters
Alarm too high
P1
temperature
Heating stop
P2
Alarm too low
P3
temperature
Table 1: Adjustment of the finer parameters via the "set" and "+" button
3. "Set" and "–": Holding both at the same will open the menu for adjusting the turning
options.
The display will show the individual parameter, displayed as number/letter combina-
tion (parameter ID).
With the "+" and "–" buttons, you can choose the various parameters.
If you wish to alter a parameter, push the "set" button, then alter the value up or down-
ward via the "+" and "–" buttons.
Pushing the "set" button again, will save the changes.
Turning para-
Parameter
meters
Turning
fre-
F1
quency
Turning
dura-
F2
tion
Table 2: Adjusting the turning via the "set" and "–" buttons
4.
"+" and "-": Holding both pushed at the same time for a longer duration (approx. 8 sec)
resets the incubator back to factory settings, there will be a peep sound
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
ID
range
0–99.9 ℃
0–99.9 ℃
0–99.9 ℃
Adjustment range
ID
0–999 min
0–999 sec
Item 51073, 51269
setting
38.8 ℃
37.8 ℃
Please note that the radiator will
switch
entered value, but will still radiate
some warmth, and the temperature
might still rise a little bit in the incub-
ator. E. g. this means that a temper-
ature of 38
when setting the temperature to
37.8
℃
. If you wish to avoid this, the
temperature of the heating stop
needs to be corrected downward.
36 ℃
Standard
setting
90 min
10 sec
off
when
reaching
℃
can be reached,
Note
When adjusting to 0, no
turning takes place.
When adjusting to 0, no
turning takes place.
Page 10
12
the
2020-1
Advertisement
