Power Cord - pro.point 8712135 User Manual

V1.0 8 in. BENCH GRINDER WITH PCB LCD READOUT
8. This device is only for use on 120 V (single phase) and is
equipped with a 3-prong grounded power supply cord
and plug.
8.1 DO NOT remove the ground prong from the plug. This
will render the tool unsafe.
9. DO NOT use this device with a 2-prong wall receptacle.
9.1 Choose an available 3-prong power outlet.
9.2 Replace 2 prong outlet with a grounded 3-prong
receptacle, installed in accordance with the CE Code
and local codes and ordinances.
WARNING! All wiring should be performed by a
qualified electrician.

POWER CORD

1. Insert the power cord plug directly to the power supply
whenever possible. Use extension cords or surge protectors
only when the tool's power cord cannot reach a power
supply from the work area.
1.1 When operating a power tool outside, use an outdoor
extension cord marked W-A or W. These cords are rated
for outdoor use and reduce the risk of electric shock.
1.2 Use in conjunction with a Ground Fault Circuit
Interrupter (GFCI). If operating a power tool in a damp
location is unavoidable, the use of a GFCI reduces the
risk of electric shock. It is recommended that the GFCI
should have a rated residual current of 30 mA or less.
2. Do not operate this tool if the power cord is frayed or
damaged as an electric shock or surge may occur, resulting
in personal injury or property damage.
2.1 Inspect the tool's power cord for cracks, fraying or
other faults in the insulation or plug before each use.
2.2 Discontinue use if a power cord feels more than
comfortably warm while operating the tool.
Visit www.princessauto.com for more information
8712135
9