pro.point 8712135 User Manual page 10

8 in. bench grinder with pcb lcd readout
Table of Contents

Advertisement

Available languages

Available languages

8712135
8 in. BENCH GRINDER WITH PCB LCD READOUT
2.3 Have the power cord replaced by a qualified
service technician.
3.
Keep all connections dry and off the ground to reduce the
risk of electric shock. Do not touch plug with wet hands.
4. Prevent damage to the power cord by observing the
following:
4.1 Do not pull on the cord to disconnect the plug from
an outlet.
4.2 Keep the power cord clear of the tool and the tool's
work path while in operation. The cord should always
stay behind the tool.
4.3 Keep cord away from heat, oil, sharp edges or
moving parts.
5.
Do not allow people, mobile equipment or vehicles to pass
over unprotected power cords.
5.1 Position power cords away from traffic areas.
5.2 Place cords in reinforced conduits.
5.3 Place planks on either side of the power cord to create
a protective trench.
6.
Do not wrap cord around the tool as sharp edges may cut
insulation or cause cracks if wound too tight. Gently coil
cord and either hang on a hook or fasten with a device to
keep cord together during storage.
UNPACKING
WARNING! Do not operate the tool if any part is missing.
Replace the missing part before operating. Failure to do so
could result in a malfunction and personal injury.
Remove the parts and accessories from the packaging and inspect
for damage. Make sure that all items in the parts list are included.
10
For technical questions call 1-800-665-8685
V1.0

Advertisement

Table of Contents
loading

Table of Contents