Supermicro SuperServer 620BT-HNTR User Manual page 86

4. Identifying bad components by isolating them: If necessary, remove a component in
question from the chassis, and test it in isolation to make sure that it works properly.
Replace a bad component with a good one.
5. Check and change one component at a time instead of changing several items at the same
time. This will help isolate and identify the problem.
6. To find out if a component is good, swap this component with a new one to see if the
system will work properly. If so, then the old component is bad. You can also install the
component in question in another system. If the new system works, the component is good
and the old system has problems.
Chapter 7: Troubleshooting and Support
86