Supermicro SuperServer 620BT-HNTR User Manual page 57

Installing PCIe 4.0 x16 Expansion Card with RSC-PR-6-X2
1. If necessary, power down
2. Open the latch at the center of the node.
3. Remove the I/O slot shield by sliding it towards the center.
4. Attach the riser card to the riser card bracket.
5. Insert the expansion card into the riser card slot.
6. Align the I/O bracket on the expansion card with the bracket lock holder on the node.
7. Continue to install the M.2 carrier-and-riser card or close the latch at the center of the
node.
Latch
PCI Slot
Note: Figure is for illustrative purposes only. Your system may or may not resemble this
picture.
Chapter 3: Maintenance and Component Installation
the node, remove it
Figure 3-13. Installing Expansion Card
57
from the chassis.
Riser Card
Riser Card Bracket