Advertisement
ASSEMBLY INSTRUCTIONS CONTINUED
MCQUEEN CHESTS
4)ADJUST DRAWERS AS REQUIRED
a)Check that the gaps between the drawers are even. If re-
quired, adjust them as follows. Pull out the drawer just far
enough to access the small grey plastic locking clips on the
rails underneath. These clips are located on the far left and
far right just near the drawer front. You can move this locking
clip forward or backward until you achieve the desired spacing
between the drawers. Close the drawer after each adjustment to
check the spacing. In most cases, you will achieve best results
by leaving the clip centred.
b) Repeat the above procedure on as many drawers as necessary,
until the desired result is achieved.
5) The assembly is now complete and the chest is ready for use.
0
3
M
A
T
T
H
E
W
H
I
L
T
O
N
Advertisement
