Setting The Nic Operating Mode - HP PtoLiant DL140 Setup And Installation Manual

To clear and reset the system configuration settings, follow the procedures outlined in "Clearing
and Resetting System Password Settings" section earlier in this chapter, except for replacing
switch position 2 for 1 in the process. After completing the steps, press the DEL key to run BIOS
Setup and reset all system configuration settings.
NOTE: For complete instructions on how to use BIOS Setup, refer to Chapter 5.

Setting the NIC Operating Mode

The NIC operating speed does not have to be set because the controllers automatically
differentiate between the 10-Mbit, 100-Mbit and 1000-Mbit environments.
To configure the PXE and WOL options press Cntl-S when prompted during POST.
HP ProLiant DL140 Server Setup and Installation Guide
All manuals and user guides at all-guides.com
55