Stand Lock Lever - Kubota LA535 Assembly Instructions Manual

BStand Lock Lever
1. Installing the lock lever bracket on the bottom of boom
with carriage bolt (square bolt).
(1) 2-Square neck bolts
(2) 2-Flange nuts
(3) Lock lever bracket
A Making sure the neck bolt location with the assembly
process below.
(i) Sand the bracket with square neck bolt and nut .
(ii) Slide these parts to fit the neck of bolts on key hole.
(iii) Tighten the nuts.
Cross section (top view)
(1) 2-Square neck bolts and nuts (A) Slide
(B) Key hole
ASSEMBLY INSTRUCTIONS
2. Install stand lock rod on the collar bolt and lever
bracket.
(1) Stand lock rod
(2) Snap pin
A Key hole on lever rod should be on the slot as below.
(1) Key hole on stand lock rod
(2) Slot
25