Table of Contents
Advertisement
1.7 Numbering
Position references to components inside the
figures are designated A, and B, etc. The figures
are number 1, 2 etc. The position references figure
numbers restart in each new
section.
1.8 General instructions
The workshop where chainsaw repairs are to be
done must be equipped with safety equipment as
set out in local regulations.
No one may repair the chainsaw unless they have
read and understood the contents of this Workshop
Manual. This Workshop Manual contains the follow-
ing warning texts in relevant places. Warning texts
are positioned before the procedures they refer to.
WARNING!
The warning box warns of the
risk of personal injury if the
instructions are not followed.
NOTE!
This text warns of material damage if the
instructions are not followed.
Introduction and safety regulations
1.9 Special instructions
The fuel used in the chainsaw has the following haz-
ardous properties:
1.
The fluid and its fumes are poisonous.
2.
Can cause skin irritation.
3.
Is highly inflammable.
The bar, chain and clutch cover (chain brake) must
be fitted before the saw is started otherwise the
clutch can work loose and cause personal injury.
Wear ear-muffs when test running.
Do not use the saw until it has been adjusted so that
the chain remains still when idling.
After test running, do not touch the muffler until it
has cooled. Risk of burn injuries.
Insufficient lubrication of the chain can result in the
chain breaking, which can cause serious or even
life-threatening injury.
Ensure that the spring in the starter does not fly out
and cause personal injury.
If the spring tension is activated on the starter pulley
when it is to be taken up, the spring can fly out and
cause personal injury.
Check that the brake is applied when removing the
pressure spring on the chain brake. Otherwise the
pressure spring can fly out and cause personal
injury.
After repair, the chain brake must be checked in ac-
cordance with the instructions on page 16.
When replacing the crankshaft bearings note that
the
crankcase halves are hot. Wear protective gloves
Do not direct the compressed air jet towards the
body when using compressed air. Air can penetrate
into the blood circulation, which means mortal dan-
ger.
English – 4
Advertisement
Table of Contents
Troubleshooting
