Cleaning And Inspection; Assembly - RedMax G9000 Workshop Manual

Tank unit

13.1.2 Cleaning and inspection

Clean all parts and check that the fuel pipe is intact.

13.1.3 Assembly

1. 1. If the chainsaw is fitted with hand grip
heating, fit the heating element if it has been
removed. See page 21 and 23.
2. 2. If a new fuel pipe is to be fitted, do as follows:
A Lightly oil in one half of the new fuel pipe.
B Press the oiled part through the hole in the tank
unit. Allow 80-85 mm to protrude on the outside.
See fig. 4.
C Turn the pipe so that it bends upwards. See fig. 4.
D Cut off the angled ends at both ends so that it
protrudes 80-85 mm on the outside.
E Remove the pipe from the tank and fit the fuel
filter. Push on the pipe as far as it will go
NOTE! Take care not to damage the fuel pipe
and throttle cable.
.
3. If the throttle lock has been removed, it should
be refitted before the tank unit and engine unit
are assembled. See page 16.
4. Lift the engine unit over the tank unit and push
the fuel pipe and throttle cable into their holes in
the bottom of the carburettor space.
5. The vent for the fuel tank is placed on the
right-hand side of the tank. See fig. 6.
6. When changing the tank vent use screws of the
"self-threading 6 mm" type to pull out the tank
vent.
7. Fit the leads on the stop switch.
8. Fit the bolts (H, J and K) on the flywheel side.
See fig. 3. Tighten the bolts to the torque in the
service data, page 10.
9. Fit the bolts (C, D, E and F). See fig. 2. Tighten
the bolts to the torque in the service data, page
12-13.
10. If the chainsaw is fitted with hand grip heating,
fit the lead at C.
11. Fit the fuel pipe (B) on the carburettor. See fig. 7.
12. Insert the throttle cable casing in the attachment
and hook on the throttle cable (A) on the
carburettor. See fig. 7.
13. Fit the cylinder cover, chain and bar. See the
Operator Guide.
Fig. 4
Fig. 5
Fig. 6
A
Fig. 7
H
B
English – 39