Assembly; Stop Switch - RedMax G9000 Workshop Manual

9.1.3 Assembly

Assemble the ignition system as follows:
1. Fit the flywheel on the spindle. Turn it gently until
the key on the flywheel mates with the recess in
the shaft.
2. Fit the flywheel washer and nut. Tighten the nut
to 35 Nm. See fig. 5.
3. Fit the two pawls on the flywheel. See fig. 6.
4. Remove the piston stop.
5. Fit the ignition module (B) without tightening its
bolts. See fig. 8.
6. Turn the flywheel so that its magnet (G) comes
opposite the ignition module. See fig. 7.
7. Insert the feeler gauge (H) (0.3 mm) between
the ignition module and the flywheel magnet.
The clearance only applies to the two lower
pegs on the ignition module. See fig. 7 and 8.
8. Push the ignition module against the flywheel
and tighten the bolts to 4 Nm.
9. Fit the cable guide (D page 21 fig. 1) and press
on the ignition cable. Connect the ignition cable
to the spark plug.
10. Pull out the cable and press home the cable clip
(F) on the ignition module. See fig. 1.
11. Fit the remaining parts on the saw. See
respective chapters.

9.2 Stop switch

The stop switch is described in the section "Safety
equipment". See page 15.
22 – English
Fig. 5
Fig. 6
H
B
G
Fig. 7
G
B
0.3 mm
Fig. 8
Electrical system