RedMax G300TS Owner's/Operator's Manual
  1. Manuals
  2. Brands
  3. RedMax Manuals
  4. Chainsaw
  5. G300TS
  6. Owner's/operator's manual
RedMax G300TS Owner's/Operator's Manual

RedMax G300TS Owner's/Operator's Manual

Zenoah chainsaw owner/operator manual
Hide thumbs

Advertisement

Table of Contents

OWNER / OPERATOR MANUAL
WARNING
The engine exhaust from this product
contains chemicals known to the State
of California to cause cancer, birth
defects or other reproductive harm.
APPLICABLE SERIAL NUMBERS :
CHAINSAWS
G310TS
Before using our products, please
read this manual carefully to
understand the proper use of your
unit.
002191 and up
2875-93111(005)
WARNING

Advertisement

Table of Contents
loading

Related Manuals for RedMax G300TS

Summary of Contents for RedMax G300TS

  • Page 1 OWNER / OPERATOR MANUAL WARNING The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. APPLICABLE SERIAL NUMBERS : CHAINSAWS G310TS Before using our products, please read this manual carefully to understand the proper use of your unit.

  • Page 3: Table Of Contents

    SAFETY FIRST Instructions contained in warnings within this manual marked with a critical points which must be taken into consideration to prevent possible serious bodily injury, and for this reason you are requested to read all such instructions carefully and follow them without fail. WARNINGS IN THE MANUAL WARNING This mark indicates instructions which must be...

  • Page 4: Parts Location

    1. Parts location 2. Specifications G310TS Power unit : Dis placement ····················································································· 1.9(30.1) cu-in(cm Fuel ············································································· Mixture(Gasoline 32 : 2-cycle oil 1) Fuel tank capacity ················································································· 7.44(0.22) fl.oz( ) Chain oil ························································································ Motor oil SAE #10W-30 Oil tank capacity ···················································································· 4.40(0.13) fl.oz( ) Carburetor ·································································································...

  • Page 5: Symbols On The Machine

    3. Symbols on the machine IMPORTANT ENGINE INFORMATION THIS ENGINE CONFORMS TO US EPA PH1 AND 1995-1998 CALIFORNIA EMISSION REGULATIONS FOR ULGE ENGINES. ENGINE FAMILY : TKZ030UB24RA ENGINE DISPLACEMENT : 30.1cc USE UNLEADED GASOLINE + AIR – COOLED 2 – CYCLE ENGINE OIL. REFER TO OWNER'S MANUMAL FOR MAINTENANCE SPECIFICATIONS AND ADJUSTMENTS.

  • Page 6: For Safe Operation

    4. For safe operation 1. Never operate a chain saw when you are fatigued, ill, or upset, or under the influence of medication that may make you drowsy, or if you are under the influence of alcohol or drugs. 2. Use safety footwear, snug fitting clothing and eye, hearing and head protection devices.

  • Page 7: Kickback Safety Precautions For Chain Saw Users

    4. For safe operation 16. Operate the chain saw only in well ventilated areas. Never start or run the engine inside a closed room or building. Exhaust fumes contain dangerous carbon monoxide. 17. Do not operate a chain saw in a tree unless specially trained to do so.

  • Page 8: Installing Guide Bar And Saw Chain

    5. Installing guide bar and saw chain A standard saw unit package contains the items as shown. (SE1) Open the box and install the guide bar and the saw chain to the power unit as follows. WARNING The saw chain has very sharp edges. Use thick, protective gloves to avoid injury.

  • Page 9: Fuel And Chain Oil

    6. Fuel and chain oil FUEL The RedMax engines are lubricated by oil specially formulated for air-cooled 2-cycle gasoline engine use. If RedMax oil is not available, use an anti- oxidant added quality oil expressly labeled for air- cooled 2-cycle engine use. RECOMMENDED MIXING RATIO GASOLINE 32 : OIL 1 Exhaust emission are controlled by the...
  • Page 10 6. Fuel and Chain oil CHAIN OIL Use motor oil SAE 10W-30 all year round, or SAE 30-40 in summer and SAE 20 in winter. NOTE Do not use waste or regenerated oil that can cause damage to the oil pump.

  • Page 11: Operation

    7. Operation FUELING THE UNIT (OP1) 1. Remove the fuel tank cap and pour fuel into the tank up to 80% of full capacity. 2. Fasten the fuel cap securely and wipe up any fuel spillage around the unit. 3. Remove the oil tank cap and pour chain oil into the tank.
  • Page 12 7. Operation CHECKING OIL SUPPLY After starting the engine, run the chain at medium speed and see if chain oil is scattered off as shown in the figure. (OP6) NOTE The oil tank should become nearly empty by the time fuel in the tank is used up. Be sure to refill the oil tank every time when refueling the saw.
  • Page 13 7. Operation so that saw chain does not turn. If idling speed is too slow, turn the screw clockwise. (OP8) 4. Make a test cut adjust the H needle for best cutting power, not for maximum speed. (OP8) CHAIN BRAKE The chain brake is a device designed to stop the saw chain quickly when kickback occured.

  • Page 14: Sawing

    8. Sawing NOTE • Before proceeding to your job, read “For Safe Operation” section. It is recommended to first practice sawing easy logs. This also helps you get accustomed to your unit. • It is not necessary to force the saw into the cut. Apply only light pressure while running the engine at full throttle.
  • Page 15 8. Sawing should stop immediately with the engine at full speed. If the chain is slow to stop or does not stop then replace the brake band and clutch drum before use. • It is extremely important that the chain brake be checked for proper operation before each use and that the chain be sharp in order to maintain the kickback...
  • Page 16 8. Sawing of bending direction to prevent the guide bar from being caught in the cutaway. Cutting an unpillowed log Saw down halfway, then roll the log over and cut from the opposite side. (SA3) Cutting a pillowed log In the area A in the picture right above, saw up from the bottom one-third and finish by sawing down from the top.

  • Page 17: Maintenance

    9. Maintenance WARNING Make sure to stop the engine before inspecting and/or servicing the unit. DAILY MAINTENANCE SAW CHAIN It is one of the essential factors for smooth and safe operation to keep the cutters always in good condition. It’s time to reform the cutters when; 1.
  • Page 18 9. Maintenance GUIDE BAR 1. Remove sawdust in the bar groove and the oiling port. (MA5) 2. Grease the nose sprocket from the feeding port on the tip of the guide bar. (MA6) 3. Periodically turn over the guide bar when mounting it to the unit, in order to prevent partial wear.
  • Page 19 9. Maintenance MA10 MA11 .025 in 0.6 mm MA12 anything wrong be found, make sure to have it repaired before next usage. MONTHLY MAINTENANCE FUEL FILTER When the engine runs short of fuel supply, check the fuel filter for blockage. (MA9) OIL STRAINER Drain the oil tank and remove the oil strainer located near the spark plug.

  • Page 20: Storage

    9. Maintenance MA13 10. Storage SPARK ARRESTER RedMax engines are equipped with a spark arresting screen at the exhaust port. Periodically check and keep it in good condition. In the State of California it is required by law (Section 4442 of the California Public Resources Code) to have a spark arrester when a gas powered tool is used in any forest covered, brush covered, or grass covered...

  • Page 21: Parts List

    11. Parts list NOTE : 1. Use KOMATSU ZENOAH genuine parts as specified in the parts list for repair and/or replacement. 2. KOMATSU ZENOAH does not warrant the machines, which have been damaged by the use of any parts other than those specified by the company.

  • Page 22: Parts List

    Fig.1 POWER UNIT G310TS (S/N 002191 and up)
  • Page 23 Q'TY Key# PART NUMBER DESCRIPTION /UNIT 2870-12111 CYLINDER 2633-15100 MUFFLER ASS’Y 2633-15110 • BASE 2633-15120 • COVER 2630-15130 • BUFFLE 2633-15150 • SPARK ARRESTER 2633-15160 COVER 2630-15210 GASKET 3330-15220 BOLT 2870-21111 CRANKCASE 11 01252-30530 BOLT 2870-22102 VALVE ASS’Y 2870-22211 GASKET 14 3330-141211 GASKET 2875-31103 ENGINE CASE COMP.
  • Page 24 G310TS 11. Parts list Fig.2 CARBBURETOR COMPONENTS & ACCESSORIES (S/N 002191 and up)
  • Page 25 Fig.2 CARBBURETOR COMPONENTS & ACCESSORIES (S/N 002191 and up) Key# PART NUMBER DESCRIPTION 2875-81001 CARBURETOR ASS'Y 3306-81380 SCREEN 2875-81120 PUMP COVER 3310-81130 SCREW 3356-81310 VALVE, inlet 3310-81280 COVER 2867-81270 SPRING 3310-81240 SCREW 3310-81250 3310-81230 LEVER 1480-81420 PLUG 3350-81380 SPRING 2630-81330 SCREW 3310-81360 SCREW...

  • Page 26: California Emission Control Warranty Statement

    MANUAL. KOMATSU ZENOAH Co. RECOMMENDS THAT YOU RETAIN ALL RECEIPTS COVERING MAINTENANCE ON YOUR LAWN AND GARDEN ENGINE, BUT KOMATSU ZENOAH Co. CAN NOT DENY WARRANTY SOLELY FOR THE LACK OF RECEIPTS OR FOR YOUR FAILURE TO ENSURE THE PERFORMANCE OF ALL SCHEDULED MAINTENANCE.
  • Page 27 EMISSION-RELATED PARTS, FOR TWO (2) YEARS FROM THE DATE OF ORIGINAL DELIVERY OF THE MODEL G310TS UNIT, KOMATSU ZENOAH AMERICA INC. (THE COMPANY), THROUGH ANY RedMax DEALER, WILL REPAIR OR REPLACE, FREE OF CHARGE, FOR THE ORIGINAL AND EACH SUBSEQUENT PURCHASER, ANY PART OR PARTS FOUND TO BE DEFECTIVE IN MATERIAL AND/OR WORKMANSHIP.
  • Page 28 ZENOAH AMERICA INC. au (770)-381-5147 Note importante: vous recevrez une carte d'enregistrement de garantie au moment de l'achat. Veuillez la remplir et l'adresser à RedMax / KOMATSU ZENOAH AMERICA sous sept (7) jours en prenant soin de conserver une copie pour vous.

This manual is also suitable for:

G310ts

Table of Contents