Appendix A Troubleshooting - Planet Networking & Communication PL-702 User Manual

Appendix A Troubleshooting

Q1：If your PL-702 has difficulty communicating with each other, check the
following:
A ：
• Try power cycling the unit by unplugging it from the wall for 10 seconds and
plugging it in again.
• Hold the security/reset button down for more than 15 seconds to reset to default
setting. The PL-702 light will flash, the units will reset and attempt to link using
default factory settings.
• Try plugging the PL-702 into an adjacent plug.
• HomePlug AV Ethernet Bridges work better when plugged directly into the wall
outlet. Connecting these Ethernet Bridges to a power strip or surge protector may
degrade network performance or completely stop network signals.
• This HomePlug AV nano Ethernet Bridge should not be used on GFI protected
outlets as some outlets will filter out HomePlug Powerline signal.
• This HomePlug AV nano Ethernet Bridge should not be used in areas with
excessive heat.
• Certain florescent or incandescent lights are noise sources on the electrical and
can degrade performance.
• If your building has more than one circuit breaker box, your HomePlug AV
Ethernet Bridges may not be able to connect between the different circuit breaker
boxes. In this case, connect one HomePlug AV Ethernet Bridge to a power outlet
located on each of the circuit boxes. Connect Ethernet cable between each of the
HomePlug AV Ethernet Bridges to link the different circuits together. This will
allow the HomePlug AV Ethernet Bridges from different circuit breaker boxes to
connect.
• To enter standby mode for this device, simply remove the Ethernet cable and wait
about 3 minutes.
User's Manual of PL-702
27