Reset Button - Planet Networking & Communication PL-702 User Manual

has been generated. It must now be linked to your network to adopt the new
network security key.
Step 9
Press and hold the security button on Bridge A for 1~3 seconds. The
Power lights on Bridge A starts to flash.
Step 10
Within 120 seconds after the Power light on Bridge A starts to flash,
press and hold the security button on Bridge C for 1~3 seconds then release.
Step 11
Bridge A, Bridge B and Bridge C is now networked to each other.

3.6 Reset Button

This section describes how to use Reset button, this button can be used to clear ALL
data and restore ALL settings to the factory default values.
The procedure is as follows:
Step 12
Hold the reset Button down while Power On for a few seconds.
Step 13
Release the reset button.
Step 14
All the LEDs will off, and then start again.
Step 15
PL-702 is now using the factory default values.
User's Manual of PL-702
26