Error Messages - Brother NX-250 Operation Manual

Symptom
The feed dogs are lowered.
The stitch is too short.
The presser foot that is used is not
appropriate for the type of stitch that
you wish to sew.
The fabric does
not feed.
The pressure of the presser foot is
weak.
The thread is tangled, for example,
in the bobbin case.
The sewing lamp
does not come on. The sewing lamp is damaged.

Error messages

If ("Start/Stop" button) is pressed before the sewing machine is correctly set up or if an operation is
performed incorrectly, an error message appears in the stitch indicator. Follow the instructions that appear.
The message may disappear if the operation is performed correctly. The message will disappear if
(Stitch selection keys) is pressed while the message is displayed.
Error Message
Probable Cause
The "Start/Stop" button or "Reverse/Reinforcement
Stitch" button was pressed while the presser foot was
raised.
A stitch other than the buttonhole or bar tack stitch was
selected and the "Start/Stop" button was pressed while
the buttonhole lever is lowered.
The buttonhole or bar tack stitch was selected and the
"Start/Stop" button was pressed while the buttonhole
lever is raised.
The "Reverse/Reinforcement Stitch" button or "Needle
Position" button was pressed while the bobbin winder is
moved to the right.
The "Start/Stop" button was pressed while the foot
controller was connected.
The motor locked up because the thread is tangled.
The needle mode selection key was pressed while a
stitch that cannot be used with twin needle sewing was
selected.
You tried to select a different stitch while the twin
needle sewing setting was selected (the key is lit).
Remedy
Slide the drop feed lever to the right
(as seen from the rear of the machine).
Lengthen the stitch length.
Attach the presser foot that is
appropriate for the type of stitch that
you wish to sew.
Turn the presser foot pressure dial to
the left to increase the pressure of
the presser foot.
Remove the tangle thread. If the
thread is tangled in the bobbin case,
clean the race.
Contact your dealer or the nearest
authorized service center.
Probable Cause
Reference
page 69, 82
page 48
page 94
page 34
page 100
–
or
Troubleshooting 105
4