Replacing The Needle - Brother NX-250 Operation Manual

Brother nx-250 sewing machines: users manual
Hide thumbs Also See for NX-250:
Table of Contents

Advertisement

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
GETTING READY

Replacing the needle

Replace the needle as described below. Use the
screwdriver and a needle that has been determined
to be straight according to the instructions in
"Checking the needle".
1
Press
("Needle Position" button) once
or twice to raise the needle.
1 "Needle Position" button
2
Turn off the sewing machine.
CAUTION
Before replacing the needle, be sure to
turn off the sewing machine, otherwise
injuries may occur if
button) is accidentally pressed and the
machine starts sewing.
Place fabric or paper under the presser foot to
3
cover the hole in the needle plate.
Note
● Before replacing the needle, cover the hole
in the needle plate with fabric or paper to
prevent the needle from falling into the
machine.
4
Lower the presser foot lever.
1 Presser foot lever
32
1
("Start/Stop"
1
5
Hold the needle with your left hand, and then
use a screwdriver to turn the needle clamp
screw toward you (counterclockwise) to
remove the needle.
1 Screwdriver
2 Needle clamp screw
• Do not apply a strong force when loosening
or tightening the needle clamp screw,
otherwise certain parts of the sewing
machine may be damaged.
6
With the flat side of the needle toward the
rear of the machine, insert the needle until it
touches the needle stopper.
1
1 Needle stopper
7
While holding the needle with your left hand,
use the screwdriver to tighten the needle
clamp screw.
Install the twin needle in the same way.
CAUTION
Be sure to insert the needle until it
touches the needle stopper and securely
tighten the needle clamp screw with the
screwdriver, otherwise the needle may
break or damage may result.
1
2

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents